hdlbits_Module_fadd

Module_fadd

In this exercise, you will create a circuit with two levels of hierarchy. Your top_module will instantiate two copies of add16 (provided), each of which will instantiate 16 copies of add1 (which you must write). Thus, you must write two modules: top_module and add1.

Like module_add, you are given a module add16 that performs a 16-bit addition. You must instantiate two of them to create a 32-bit adder. One add16 module computes the lower 16 bits of the addition result, while the second add16 module computes the upper 16 bits of the result. Your 32-bit adder does not need to handle carry-in (assume 0) or carry-out (ignored).

Connect the add16 modules together as shown in the diagram below. The provided module add16 has the following declaration:

module add16 ( input[15:0] a, input[15:0] b, input cin, output[15:0] sum, output cout );

Within each add16, 16 full adders (module add1, not provided) are instantiated to actually perform the addition. You must write the full adder module that has the following declaration:

module add1 ( input a, input b, input cin, output sum, output cout );

Recall that a full adder computes the sum and carry-out of a+b+cin.

In summary, there are three modules in this design:

• top_module — Your top-level module that contains two of...
• add16, provided — A 16-bit adder module that is composed of 16 of...
• add1 — A 1-bit full adder module.

If your submission is missing a module add1, you will get an error message that says Error (12006): Node instance "user_fadd[0].a1" instantiates undefined entity "add1".

Module_fadd

Hint

Full adder equations:

sum = a ^ b ^ cin

cout = a&b | a&cin | b&cin

solution

module top_module (
    input [31:0] a,
    input [31:0] b,
    output [31:0] sum
);//

    wire cout;
    add16 add1(.a(a[15:0]), .b(b[15:0]), .cin(1'b0), .cout(cout), .sum(sum[15:0]));
    add16 add2(.a(a[31:16]), .b(b[31:16]), .cin(cout), .sum(sum[31:16]));
    
endmodule

module add1 ( input a, input b, input cin,   output sum, output cout );

// Full adder module here
	assign sum  = a^b^cin;
    assign cout = a&b | a&cin | b&cin;
    
endmodule